Datasheet

4
Subject to change without notice
Important hints
Important hints
After unpacking please check for mechanical
damage and loose par ts oating around inside the
instrument. In case of damage please inform the
transport company immediately. Do not operate
the instrument and protect it against unauthorized
operation.
Symbol:
Please consult the manual
Safety instructions
The instrument conform to the European stan-
dards EN 61010-1 and IEC 61010-1, respectively.
Further Safety Informations
To avoid personal injury and to prevent re or
damage to this product or products connected
to it, review and comply with the following safety
precautions. Be aware that if you use this probe
assembly in a manner not specied the protection
this product provides may be impaired.
– Only qualied personnel should use this
probe assembly.
– Use only grounded instruments.
– Connect and disconnect properly.
– Connect the probe output to the measure-
ment instrument and connect the ground
lead to earth ground before connecting the
probe to the circuit under test. Disconnect
the probe input and the probe ground lead
from the circuit under test before discon-
necting the probe from the measurement
instrument. Observe probe ratings.
– Do not apply any electrical potential to the
probe input which exceeds the maximum
ratings of the probe.
– Keep away from live circuits.
– Avoid open circuitry. Do not touch con-
nections or components when power is
present.
– Do not operate with suspected failures.
– Repair only by qualied service personnel.
– Indoor use only.
– Do not operate in wet/damp environment.
Keep product surfaces dry and clean.
– Do not operate the product in an explosive
atmosphere.
Operating conditions
The permissible operating temperature is +5 °C
to +40 °C. During transport and storage the
temperature may be –20 °C to +70 °C. In case of
condensation after transport it is necessary to
dry the probe for at least 2 hrs. prior to operation.
Operate only in clean, dry rooms.
Warranty and Repair
Our instruments are subject to strict quality con-
trols. Prior to leaving the manufacturing site, each
instrument undergoes a 10-hour burn-in test. This
is followed by extensive functional quality testing
to examine all operating modes and to guarantee
complianc e with the specied technic al dat a. The
testing is performed with test equipment that is
calibrated to national standards. The statutory
warranty provisions shall be governed by the laws
of the country in which the product was pur-
chased. In case of any complaints, please contact
your supplier.
Any adjustments, replacements of parts, main-
tenance and repair may be carried out only by
authorized technical personnel. Only original
parts may be used for replacing parts relevant to
safety (e.g. power switches, power transformers,
fuses). A safety test must always be performed
The product may only be opened by authorized
and qualied personnel. Prior to working on the
product or before the product is opened, it must
be disconnected from the AC supply network.
Otherwise, personnel will be exposed to the risk
of an electric shock.