Datasheet

12
Digital inputs and outputs are optionally available. They
can be used as trigger/inhibit inputs and control/fault out-
puts. The hardware of the R&S®NGM-K103 option is pre-
installed. The function can be activated using a keycode
(to be ordered separately).
Full remote capabilities
For use in test systems, the R&S®NGM200 power supply
series can be remotely controlled. The following interfaces
are available.
USB and LAN
USB and LAN (Ethernet) interfaces are installed as stan-
dard. All supply parameters can be remotely controlled via
these interfaces.
Wireless LAN (R&S®NGM-K102 option)
As an alternative, the R&S®NGM200 power supplies can
be remotely controlled via the WLAN interface. The WLAN
module, which is activated by keycode (to be ordered
separately), supports CLIENT mode, which means that the
power supplies automatically connect to a network.
Note: The WLAN function is not available in all regions
due to country-specific regulations.
IEEE-488 (GPIB) interface (R&S®NGM-B105 option)
The R&S®NGM-B105 interface with an IEEE-488 (GPIB)
port is available as an option that can be ordered
ex-factory.
Fast on the bus and on the bench
Complicated measurement sequences require ever faster
setting, measuring and command processing times. The
R&S®NGM200 power supplies meet these needs. Thanks
to a state-of-the-art multicore architecture, they not only
process control commands much faster than conventional
power supplies, they process them internally in parallel.
Users benefit from this in ATE systems. There are also
advantages in manual operation, such as faster sequences
in Arb mode.
Advanced instrument design: compact form
factor, quiet operation
There is never enough space on the bench or in the rack.
The R&S®NGM200 power supplies take up very little space
thanks to their compact design.
Since the built-in fan is temperature-controlled, it often
runs at a low speed or powers down completely, resulting
in very low operating noise.
Ideal for use in labs
and test systems
Tailored for use in labs and system racks
The R&S®NGM200 power supplies are the right choice for
challenging applications. They are used in R&D labs and
integrated into production test systems.
The power supplies can be installed in 19" racks using the
R&S®HZN96 rack adapter. Connectors on the rear panel
and a compact design are important criteria for use in test
systems.
Sense function
There is often a significant voltage drop over the supply
leads, especially in applications with high current
consumption. Since power supplies usually maintain a
constant output voltage, the voltage on the DUT will be
lower than the voltage displayed on the power supply. The
sense function compensates for this voltage drop over
the supply leads. The voltage actually present at the load
is measured by an additional pair of sense lines, and this
value is used to regulate the voltage directly at the load.
The connectors for the sense lines are located on the rear
panel. The R&S®NGM201 also has sense line connectors
on the front panel.
Front and rear connectors
The safety sockets on the front panel of the R&S®NGM200
power supplies are designed for 4 mm banana plugs.
Additional connections for all channels (including sense
lines) are provided on the rear panel to simplify use in rack
systems.
All connections are also provided on the rear panel
(example: R&S®NGM202 with IEEE-488 option installed).
NGM200_dat_en_3609-1685-32_v0100.indd 12 22.05.2019 11:54:19