User Manual

Remote Control
R&S
®
NGE100B
92User Manual 5601.1343.02 ─ 04
Usage: Setting only
ARBitrary:REPetitions <Repetitions>
This command defines or queries the repetition of the defined arbitrary waveform for
channel 1.
Note: If the repetition is set to "0", the arbitrary waveform repeats continuously.
Parameters:
<Repetitions> 0..255
Example:
ARB:REP 10
Set the repetition rate of the defined arbitrary waveform as 10.
ARB:REP? -> 10
Return the defined repetition rate of the selected channel.
ARBitrary:POINts?
This command returns the number of arbitrary points of EasyArb waveform.
Return values:
<arg0>
Usage: Query only
ARBitrary[:STATe] <arg0>
This command activates/deactivates or queries the EasyArb state. ON: Ch 1 is ready
to run arb waveform.
Parameters:
<arg0>
ARBitrary:SAV <arg0>
This command saves EasyArb settings and previous defined arbitrary points into the
respective memory locations M1-M5.
Parameters:
<arg0> Range: 0..4
Example: INST 1
ARB:DATA 10,1,0,5,0
ARB:REP 10
ARB:SAV 1
Usage: Setting only
Remote Control - Commands