User Manual

Remote Control

R&S

NGE100B

85User Manual 5601.1343.02 ─ 04

channel Ch 3

Example:

INST OUT1

FUSE:LINK 2

FUSE:UNL 2

Fuse Ch 1 is unlinked with Ch 2

Usage: Setting only

FUSE[:STATe] <arg0>

This command defines or queries the fuse for the previous selected channel.

Parameters:

<arg0> {0 | 1}

Fuse will be activated.

Fuse will be deactivated.

*RST: OFF | 0

Example:

INST OUT1

FUSE ON

Fuse of Ch 1 is activated

FUSE? -> 1

Return fuse state of the selected channel.

6.5.8 OVP Setting

[SOURce:]VOLTage:PROTection:MODE <arg0>

This command defines or queries the OVP mode for the previous selected channel.

Parameters:

<arg0> MEASured | PROTected

MEASured

The OVP switches off if the measured value exceeds the thresh-

old.

PROTected

If the adjusted threshold is exceeded the output of the instru-

ment will be not switched on; additionally the measured value is

monitored (please also refer to function MEASured).

Example:

INST OUT1

VOLT:PROT:MODE PROT

Sets OVP protected mode for Ch 1.

VOLT:PROT:MODE? -> PROT

Return the selected channel OVP mode.

Remote Control - Commands