User Manual

Remote Control
R&S
®
NGE100B
81User Manual 5601.1343.02 ─ 04
OUTPut2 | OUTP2
Ch 2
OUTPut3 |OUTP3
Ch 3
Example:
INSTrument OUTPut1
INSTrument OUTP1
Selects the output channel as Ch 1.
INST? -> 2
Return the output channel as Ch 2.
6.5.6 Output Setting
OUTPut[:STATe] <arg0>
This command defines or queries for output state for the previous selected channel.
Parameters:
<arg0> {OFF | ON | 0 | 1}
ON | 1
Output state will be turned on.
OFF | 0
Output state will be turned off.
*RST: OFF | 0
Example:
INST OUT1
OUTP ON
Ch 1 and output state will be activated; i.e. Ch 1 and Output key
on the front panel will be illuminated.
OUTP? -> 1
Return the output state.
OUTPut:GENeral <arg0>
This command activates or queries the instrument master output state.
If the master output state is activated, the Output key on the front panel will be illumi-
nated.
Parameters:
<arg0> {OFF | ON | 0 | 1}
ON | 1
Output state will be activated
OFF | 0
Output state will be deactivated
Remote Control - Commands