User Manual

Remote Control
R&S
®
FPC
319User Manual 1178.4130.02 ─ 05
●
Delta marker position: set to next peak:
CALCulate<n>:DELTamarker<m>:MAXimum:NEXT
●
Delta marker position: set to minimum:
CALCulate<n>:DELTamarker<m>:MINimum[:PEAK]
CALCulate<n>:MARKer<m>:MODE.................................................................................319
CALCulate<n>:MARKer<m>:Y?.......................................................................................319
DISPlay<n>:IMPedance:REFerence:POSition...................................................................320
CALCulate<n>:MARKer<m>:MODE <MarkerMode>
This command selects the type of information a marker shows.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<MarkerMode> See table below for supported parameters.
*RST: NORMal
ADMittance admittance in complex format (real + imaginary)
IMPedance impedance in complex format (real + imaginary)
NADMittance standardized admittance in complex format (real +
imaginary)
NIMPedance standardized impedance in complex format (real +
imaginary)
NORMal normal marker
RPDB reflection coefficient in complex format (magnitude
(dB) + phase)
RPL reflection coefficient in complex format (magnitude
(lin) + phase
RSCalar reflection coefficient in complex format (real + imagi-
nary)
CALCulate<n>:MARKer<m>:Y?
This command queries the measurement results at the marker position.
If necessary, the corresponding marker is activated first.
To get a valid result, you have to perform a complete sweep with synchronization to the
sweep end between activating the delta marker and reading out the result. This is only
possible in single sweep mode.
Suffix:
<n>
.
irrelevant
<m> Marker
Remote Commands of the VNA Application