User Manual

Remote Control
R&S
®
FPC
317User Manual 1178.4130.02 ─ 05
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF | 0
Example: //Turn on automatic span
FREQ:SPAN:AUTO ON
17.16.4 Bandwidth
Commands to configure the bandwidth described elsewhere.
●
Resolution bandwidth:
[SENSe:]BANDwidth[:RESolution]
[SENSe:]BANDwidth[:RESolution]:AUTO
17.16.5 Sweep
Commands to configure the sweep described elsewhere.
●
Sweep mode:
INITiate:CONTinuous
●
Initiate measurement:
INITiate[:IMMediate]
[SENSe:]SWEep:POINts.................................................................................................317
[SENSe:]SWEep:POINts <SweepPoints>
This command defines the number of measurement points.
Parameters:
<SweepPoints> <numeric value> (integer only)
Range: 101 to 2501
*RST: 201
Example: //Define number of measurement points
SWE:POIN 1001
17.16.6 Trace
Commands to configure traces described elsewhere.
●
Trace mode:
DISPlay<n>[:WINDow]:TRACe<t>:MODE
Note: Only "Clear/Write" and "Average" are supported by the VNA application.
●
Memory trace:
CALCulate<n>:MATH<t>:COPY:MEMory
DISPlay<n>[:WINDow]:TRACe<t>:MEMory[:STATe]
●
Data format of trace export:
Remote Commands of the VNA Application