User Manual

Remote Control
R&S
®
FPC
316User Manual 1178.4130.02 ─ 05
Example: //Define lower value of the y-axis in SWR
MEAS:MODE DTF
MEAS:FORM VSWR
DISP:VSWR:Y:SCAL:MIN 1
17.16.3 Frequency
Commands to configure the frequency described elsewhere.
●
Center frequency:
[SENSe:]FREQuency:CENTer
●
Span:
[SENSe:]FREQuency:SPAN
●
Start frequency:
[SENSe:]FREQuency:STARt
●
Stop frequency:
[SENSe:]FREQuency:STOP
●
Frequency mode (frequency / channel):
[SENSe:]FREQuency:INPut:MODE
●
Channel selection:
[SENSe:]CHANnel
[SENSe:]FREQuency:SETTings:COUPling:ENABle...........................................................316
[SENSe:]FREQuency:SPAN:AUTO..................................................................................316
[SENSe:]FREQuency:SETTings:COUPling:ENABle <State>
This command couples or decouples the frequency settings of the DTF measurement
to the other VNA measurements.
Parameters:
<State> ON | 1
Frequency settings are coupled. When you change the fre-
quency or span in the DTF measurement, they also change in
the other VNA measurements (reflection, transmission and cable
loss).
OFF | 0
Frequency settings of the DTF measurement are independent.
When you change the frequency or span in the DTF measure-
ment, they do not change in the other VNA measurements
(reflection, transmission and cable loss).
*RST: ON
Example: //Decouple frequency and span
FREQ:SETT:COUP:ENAB OFF
[SENSe:]FREQuency:SPAN:AUTO <State>
This command turns the automatic calculation of the ideal span on and off.
Remote Commands of the VNA Application