User Manual

Remote Control
R&S
®
FPC
285User Manual 1178.4130.02 ─ 05
TRACe[:DATA]?
This command queries the trace data (measurement results in graphical result dis-
plays).
Query parameters:
<ResultType> If you do not specify a parameter, the command queries the lat-
est measurement results.
PHOLd
Queries the maxhold information of the bargraph or frequency
scan.
Return values:
<Result> When you query the fixed frequency measurement result, the
command returns one value: the level for the current receiver
frequency.
When you query frequency scan results, the command returns
several level values. The number of return values depends on
the number of measurement frequencies.
Example: //Query measurement results
TRAC?
//Query maxhold information
TRAC? PHOL
Usage: Query only
17.13.8 Marker
Note that markers are only available for the frequency scan.
Commands to configure markers described elsewhere.
●
Marker state (on / off):
CALCulate<n>:MARKer<m>[:STATe]
CALCulate<n>:MARKer<m>:AOFF
●
Marker input mode:
CALCulate<n>:MARKer<m>:FREQuency:MODE
●
Marker position:
CALCulate<n>:MARKer<m>:X
CALCulate<n>:MARKer<m>:Y?
●
Marker position: set to peak:
CALCulate<n>:MARKer<m>:MAXimum[:PEAK]
●
Marker position: set to next peak:
CALCulate<n>:MARKer<m>:MAXimum:NEXT
●
Marker position: set to minimum:
CALCulate<n>:MARKer<m>:MINimum[:PEAK]
●
Marker search range:
CALCulate<n>:MARKer<m>:X:SLIMits<slim>:LEFT
CALCulate<n>:MARKer<m>:X:SLIMits<slim>:RIGHt
Remote Commands of the Receiver Application