User Manual

Remote Control
R&S
®
FPC
281User Manual 1178.4130.02 ─ 05
[SENSe:]SCAN:STARt <Frequency>
This command defines the start frequency for a frequency scan.
Prerequisites for this command
●
Select frequency scan ([SENSe:]FREQuency:MODE).
Parameters:
<Frequency> <numeric value>
Default unit: Hz
Example: //Define scan range with measurement every 10 MHz
FREQ:MODE SCAN
SCAN:STAR 30MHZ
SCAN:STOP 100MHZ
SCAN:STEP 10MHZ
[SENSe:]SCAN:STEP <StepSize>
This command defines the frequency step size for a frequency scan.
Prerequisites for this command
●
Select frequency scan ([SENSe:]FREQuency:MODE).
Parameters:
<StepSize> <numeric value>
Default unit: Hz
Example: //Define scan range with measurement every 10 MHz
FREQ:MODE SCAN
SCAN:STAR 30MHZ
SCAN:STOP 100MHZ
SCAN:STEP 10MHZ
[SENSe:]SCAN:STOP <Frequency>
This command defines the start frequency for a frequency scan.
Prerequisites for this command
●
Select frequency scan ([SENSe:]FREQuency:MODE).
Parameters:
<Frequency> <numeric value>
Default unit: Hz
Example: //Define scan range with measurement every 10 MHz
FREQ:MODE SCAN
SCAN:STAR 30MHZ
SCAN:STOP 100MHZ
SCAN:STEP 10MHZ
Remote Commands of the Receiver Application