User Manual

Remote Control
R&S
®
FPC
277User Manual 1178.4130.02 ─ 05
You can query the result of the limit check with CALCulate<n>:LIMit<k>:FAIL?
Prerequisites for this command
●
Select a limit line or define a threshold limit with one of the following commands:
– CALCulate<n>:LIMit<k>:LOWer:SELect
– CALCulate<n>:LIMit<k>:LOWer:THReshold
– CALCulate<n>:LIMit<k>:UPPer:SELect
– CALCulate<n>:LIMit<k>:UPPer:THReshold
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF | 0
Example: //Activate limit check
CALC:LIM:UPP:THR -70
CALC:LIM:STAT ON
CALCulate<n>:LIMit<k>:UNIT:X?
This command queries the unit of a limit line on the x-axis.
Prerequisites for this command
●
Select a limit line or define a threshold limit with one of the following commands:
– CALCulate<n>:LIMit<k>:LOWer:SELect
– CALCulate<n>:LIMit<k>:LOWer:THReshold
– CALCulate<n>:LIMit<k>:UPPer:SELect
– CALCulate<n>:LIMit<k>:UPPer:THReshold
Suffix:
<n>
.
irrelevant
<k> Limit line
Return values:
<Unit>
Example: //Query the x-unit of the first limit line.
CALC:LIM:UPP:THR -70
CALC:LIM:UNIT:X?
Usage: Query only
CALCulate<n>:LIMit<k>:UNIT[:Y]?
This command queries the level unit of a limit line.
Remote Commands of the Spectrum Application