User Manual

Remote Control
R&S
®
FPC
273User Manual 1178.4130.02 ─ 05
Suffix:
<n>
.
irrelevant
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF | 0
Example: //Turn on display line
CALC:DLIN:STAT ON
17.12.11 Limit Lines
CALCulate<n>:LIMit<k>:BEEP[:STATe]............................................................................ 273
CALCulate<n>:LIMit<k>:COMMent?................................................................................ 273
CALCulate<n>:LIMit<k>:DEFine......................................................................................274
CALCulate<n>:LIMit<k>:DELete......................................................................................275
CALCulate<n>:LIMit<k>:FAIL?........................................................................................ 275
CALCulate<n>:LIMit<k>:LOWer:SELect........................................................................... 276
CALCulate<n>:LIMit<k>:LOWer:THReshold..................................................................... 276
CALCulate<n>:LIMit<k>:STATe........................................................................................276
CALCulate<n>:LIMit<k>:UNIT:X?.....................................................................................277
CALCulate<n>:LIMit<k>:UNIT[:Y]?...................................................................................277
CALCulate<n>:LIMit<k>:UPPer:SELect............................................................................278
CALCulate<n>:LIMit<k>:UPPer:THReshold...................................................................... 278
CALCulate<n>:LIMit<k>:BEEP[:STATe] <State>
This command turns the beeper that beeps if a limit line is violated on and off.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF | 0
Example: //Activate the audio beep
CALC:LIM:BEEP ON
CALCulate<n>:LIMit<k>:COMMent?
This command queries the description of a limit line.
Prerequisites for this command
●
Select a limit line or define a threshold limit with one of the following commands:
– CALCulate<n>:LIMit<k>:LOWer:SELect
– CALCulate<n>:LIMit<k>:LOWer:THReshold
– CALCulate<n>:LIMit<k>:UPPer:SELect
Remote Commands of the Spectrum Application