User Manual

Remote Control
R&S
®
FPC
264User Manual 1178.4130.02 ─ 05
CALCulate<n>:MARKer<m>[:STATe] <State>
This command turns markers on and off.
If you do not use a suffix at MARKer, marker 1 is turned on. If one or more delta mark-
ers (2 to 6) are already active, the command turns these delta markers into normal
markers.
Suffix:
<n>
.
irrelevant
<m> Marker
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF | 0
Example: //Turn on marker 3
CALC:MARK3 ON
CALCulate<n>:MARKer<m>:X
<Position>
This command positions a marker on a certain coordinate on the x-axis.
If one or more delta markers (2 to 6) are already active, the command turns these delta
markers into normal markers.
Note that it is possible to place the marker outside the visible trace. In that case, this
value is invalid.
If necessary, the corresponding delta marker is activated first.
Suffix:
<n>
.
irrelevant
<m> Marker
Parameters:
<Position> <numeric value>
The unit depends on the measurement and marker input mode.
Hz for measurements in the frequency domain.
s for measurements in the time domain.
No unit for channel input mode (CALCulate<n>:MARKer<m>:
FREQuency:MODE).
Example: //Position marker 2 to frequency 10.7 MHz
CALC:MARK2:X 10.7MHz
CALCulate<n>:MARKer<m>:X:SLIMits<slim>:LEFT <SearchLimit>
This command defines the left limit of the marker search range.
Remote Commands of the Spectrum Application