User Manual

Remote Control
R&S
®
FPC
255User Manual 1178.4130.02 ─ 05
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF | 0
Example: //Store trace 1 into memory and turn on memory trace
DISP:TRAC1 ON
DISP:TRAC1:MODE AVER
CALC:MATH1:COPY:MEM
DISP:TRAC:MEM ON
DISPlay<n>[:WINDow]:TRACe<t>:MODE <TraceMode>
This command selects the trace mode.
If you are using the average trace mode, you can set the number of measurements
with [SENSe:]SWEep:COUNt. Note that synchronization to the end of the average
count is possible only in single sweep mode.
Suffix:
<n>
.
irrelevant
<t> Trace
Parameters:
<TraceMode> You can turn off the trace with DISPlay<n>[:WINDow]:
TRACe<t>[:STATe] (trace mode "Blank").
For more information about the trace modes, see"Selecting the
trace mode" on page 110.
AVERage
"Average" trace mode.
MAXHold
"Max Hold" trace mode.
MINHold
"Min Hold" trace mode.
VIEW
"View" trace mode.
WRITe
"Clear / Write" trace mode.
*RST:
WRITe
Example: //Select trace mode
DISP:TRAC:MODE AVER
DISPlay<n>[:WINDow]:TRACe<t>[:STATe] <State>
This command turns a trace on and off.
Suffix:
<n>
.
irrelevant
<t> Trace
Remote Commands of the Spectrum Application