User Manual

Remote Control
R&S
®
FPC
240User Manual 1178.4130.02 ─ 05
[SENSe:]FREQuency:OFFSet <FrequencyOffset>
This command defines a frequency offset.
Parameters:
<FrequencyOffset> <numeric value>
Range: depends on the start frequency to 100 GHz
*RST: 0 Hz
Default unit: Hz
Example: //Define a frequency offset
FREQ:OFFS 100MHZ
[SENSe:]FREQuency:SPAN <Span>
This command defines the frequency span.
If you define a span of 0 Hz, the R&S FPC starts a measurement in the time domain.
Parameters:
<Span> <numeric value>
Refer to the datasheet for details on the frequency range of your
R&S FPC.
*RST: fmax with fmax = maximum frequency
Default unit: Hz
Example: //Define frequency span
FREQ:SPAN 10MHZ
[SENSe:]FREQuency:SPAN:FULL
This command restores the full span.
Refer to the datasheet for details on the frequency range of your R&S FPC.
Example:
//Restore full span
FREQ:SPAN:FULL
Usage: Event
[SENSe:]FREQuency:STARt <Frequency>
This command defines the start frequency for measurements in the frequency domain
(span > 0).
Parameters:
<Frequency> <numeric value>
Refer to the datasheet for details on the frequency range of your
R&S FPC.
*RST: 0 Hz
Default unit: Hz
Remote Commands of the Spectrum Application