User Manual

Remote Control
R&S
®
FPC
236User Manual 1178.4130.02 ─ 05
[SENSe:]CHANnel:TABLe:SET........................................................................................237
[SENSe:]FREQuency:CENTer......................................................................................... 238
[SENSe:]FREQuency:CENTer:STEP................................................................................238
[SENSe:]FREQuency:CENTer:STEP:LINK........................................................................238
[SENSe:]FREQuency:INPut:MODE..................................................................................239
[SENSe:]FREQuency:MODE...........................................................................................239
[SENSe:]FREQuency:OFFSet......................................................................................... 240
[SENSe:]FREQuency:SPAN............................................................................................240
[SENSe:]FREQuency:SPAN:FULL................................................................................... 240
[SENSe:]FREQuency:STARt........................................................................................... 240
[SENSe:]FREQuency:STOP............................................................................................241
[SENSe:]CHANnel <ChannelNumber>
This command selects the channel to be analyzed.
Prerequisites for this command
●
Select channel table frequency mode ([SENSe:]FREQuency:INPut:MODE).
Parameters:
<ChannelNumber> <numeric value> (integer only)
*RST: depends on the channel table
Example: See [SENSe:]CHANnel:TABLe:SELect
[SENSe:]CHANnel:TABLe:SELect:DOWNlink <ChannelTable>
This command selects a channel table configured for downlink signals.
Prerequisites for this command
●
Select downlink mode ([SENSe:]CHANnel:TABLe:SET).
Parameters:
<ChannelTable> String containing the name of the channel table.
*RST: ' '
Example: See [SENSe:]CHANnel:TABLe:SELect
[SENSe:]CHANnel:TABLe:SELect:UPLink <ChannelTable>
This command selects a channel table configured for uplink signals.
Prerequisites for this command
●
Select uplink mode ([SENSe:]CHANnel:TABLe:SET).
Parameters:
<ChannelTable> String containing the name of the channel table.
*RST: ' '
Example: See [SENSe:]CHANnel:TABLe:SELect
Remote Commands of the Spectrum Application