User Manual

Remote Control
R&S
®
FPC
231User Manual 1178.4130.02 ─ 05
Parameters:
<ChannelBW> <numeric value>
*RST: 3.84 MHz
Default unit: Hz
Example: //Define a channel bandwidth
CALC:MARK:FUNC:OBW:BAND 1 MHZ
CALCulate<n>:MARKer<m>:FUNCtion:OBW:BANDwidth:PCT <Percentage>
CALCulate<n>:MARKer<m>:FUNCtion:OBAN:BANDwidth:PCT <Percentage>
This command defines the percentage of the total power that defines the occupied
bandwidth.
Suffix:
<n>, <m>
.
irrelevant
Parameters:
<Percentage> <numeric value>
Range: 10 to 99.9%
*RST: 99%
Example: //Define power percentage
CALC:MARK:FUNC:OBW:BAND:PCT 95
17.12.1.5 TDMA Power
The following remote commands are exclusive to the TDMA power measurement.
Commands to configure TDMA power measurements described elsewhere.
●
Sweep time:
[SENSe:]SWEep:TIME
CALCulate<n>:MARKer<m>:FUNCtion:TDMA:BURSt....................................................... 231
CALCulate<n>:MARKer<m>:FUNCtion:TDMA:BURSt <BurstLength>
This command defines the burst length of the TDMA signal.
Prerequisites for this command
●
Turn on TDMA power measurement (CALCulate<n>:MARKer<m>:FUNCtion:
POWer:SELect).
Suffix:
<n>, <m>
.
irrelevant
Parameters:
<BurstLength> <numeric value>
The value range depends on the current sweep time.
*RST: 470 us
Default unit: s
Remote Commands of the Spectrum Application