User Manual

ManualsBrandsRohde & Schwarz ManualsSignal Generators & Spectrum AnalysersFULLY LOADED Spectrum Analyser Bundle, 1GHz, 50Ohm

201

202

203

204

205

206

207

208

209

210

Remote Control

R&S

FPC

201User Manual 1178.4130.02 ─ 05

Parameters:

<SubnetMask> String containing the subnet mask ('x.x.x.x').

*RST: '255.255.255.0'

Example: //Select subnet mask

SYST:COMM:SOCK:DHCP OFF

SYST:COMM:LAN:SUBM '255.255.255.0'

SYSTem:COMMunicate:SOCKet:ADDRess <IPAddress>

This command defines the IP address of the R&S FPC.

Prerequisites for this command

●

Turn off DHCP (SYSTem:COMMunicate:SOCKet:DHCP[:STATe]).

Parameters:

<IPAddress> String containing the IP address ('x.x.x.x').

*RST: '172.76.68.24'

Example: //Define IP address

SYST:COMM:SOCK:DHCP OFF

SYST:COMM:SOCK:ADDR '192.0.2.0'

SYSTem:COMMunicate:SOCKet:DHCP[:STATe] <State>

This command turns the Dynamic Host Configuration Protocol (DHCP) on and off.

When you turn on DHCP, the network automatically assigns IP address, subnet mask

and gateway to the R&S FPC.

Parameters:

<State> ON | OFF | 1 | 0

*RST: ON | 1

Example: //Activate DHCP

SYST:COMM:SOCK:DHCP ON

17.5 System Configuration

DIAGnostic[:SERVice]:IDENtification:MATerial?.................................................................202

DIAGnostic[:SERVice]:IDENtification:SERial?................................................................... 202

DISPlay:DATE:FORMat.................................................................................................. 202

SYSTem:BNC:MODE..................................................................................................... 202

SYSTem:DATE.............................................................................................................. 203

SYSTem:ERRor:ALL?.....................................................................................................203

SYSTem:ERRor:CODE:ALL?.......................................................................................... 203

SYSTem:ERRor:CODE[:NEXT]?......................................................................................204

SYSTem:ERRor:COUNt?................................................................................................204

SYSTem:ERRor[:NEXT]?................................................................................................204

System Configuration