User Manual

The Receiver Application
R&S
®
FPC
138User Manual 1178.4130.02 ─ 05
Trigger settings in the receiver application described elsewhere:
●
"Free Run": Chapter 12.7, "Trigger Configuration", on page 107
●
"External Rise": Chapter 12.7, "Trigger Configuration", on page 107
●
"External Fall": Chapter 12.7, "Trigger Configuration", on page 107
13.7 Trace Configuration
Access: "Trace"
Access: "Setup" > "Config Overview" > "Analysis" (selected settings)
Remote commands to configure traces:
●
Chapter 17.13.7, "Traces", on page 284
Trace settings in the receiver application described elsewhere:
●
"Trace Mode": Chapter 12.8.1, "Trace Mode", on page 109
(Note that the "Blank" and "View" trace modes are not available in the receiver.)
●
"Detector": Chapter 12.8.2, "Detector", on page 111
The receiver application only supports the "Max Peak", "Average" and "RMS"
detector.
In addition, the receiver application also has the "Quasi Peak" detector. The quasi-
peak detector displays the maximum value weighted to CISPR 16-1-1 that was
detected during the measurement.
●
"Memory" / "Trace > Memory": Chapter 12.8.3, "Memory Traces", on page 112
●
"Trace Style": "Selecting the trace style" on page 130
13.8 Marker Configuration
Access: "Mkr"
Access: "Mkr →"
Remote commands to control marker:
●
Chapter 17.13.8, "Marker", on page 285
Note that markers are only available for frequency scans.
Marker settings in the receiver application described elsewhere:
●
"Mkr" > "Marker <x>": Chapter 12.9.1, "Marker Positioning", on page 115
●
"Mkr" > "Marker Type": "Selecting the marker type" on page 117
●
"Mkr" > "Marker Demodulation": Chapter 12.10.4, "Marker Demodulation",
on page 122
●
"Mkr" > "All Markers Off": "Removing markers or delta markers" on page 117
●
"Mkr→" > "Set to <x>": Chapter 12.9.2, "Automatic Marker Positioning",
on page 117
●
"Mkr→" > "Search Ranges": Chapter 12.9.3, "Marker Search Ranges", on page 118
Marker Configuration