User Manual

The Spectrum Application
R&S
®
FPC
119User Manual 1178.4130.02 ─ 05
The R&S FPC draws another vertical line at the position you selected and labels it
with 1 (for search range 1).
Figure 12-19: Marker search range lines
8. To use search range 1 for measurements, select the "Set to Search Range 1"
menu item.
The R&S FPC then uses the search range for the "Set To Peak", "Set To Next
Peak", "Set To Minimum" and "All Marker To Peak" functions and positions the
markers or delta markers inside this range.
Note: You can also define a second marker search range by selecting the "Search
Range 2" menu item and repeating the other actions the same way.
Turning off marker search ranges
1. Press the "Mkr→" key to open the marker positioning menu.
2. Select the "Search Range Off" menu item.
The R&S FPC deactivates all search ranges and deletes the vertical lines of the
search ranges.
12.10 Marker Functions
Access: "Mkr"
Remote commands required to control marker functions:
●
Chapter 17.12.8, "Marker", on page 258
Marker functions are measurements that you can perform with markers. Depending on
the marker function you have selected, the R&S FPC measures certain signal charac-
teristics on the marker position.
The marker functions are applied to the currently selected marker.
Marker Functions