User manual
77
Optional Accessories
13.4 NeareldprobesetsR&S®HZ530/HZ540
The set includes 3 hand-held probes with a built-in pre-
amplier covering the frequency range from 100 kHz to
1 GHz resp. 1 MHz to 3 GHz. When used in conjuction with
a spectrum analyzer or a measuring receiver, the probes
can be used to locate and qualify EMI sources, as well
as evaluate EMC problems at the breadboard and proto-
type level. The power can be supplied either from batteries
(R&S®HZ530) or through a power cord directly connected
to an spectrum analyzer (R&S®HZ540). Signal feed is via a
BNC-cable or SMA/N-cable. They enable the user to evalu-
ate radiated elds and perform shield effectiveness com-
parisons. The R&S®HZ530 or R&S®HZ540 probes – one
magnetic eld probe, one electric eld probe and one high
impedance probe – are all matched to the 50 Ω inputs of
spectrum analyzers. The technical specications you can
nd in the manual of the R&S®HZ530/HZ540.
Our probes are only used for so-called relative measurements.
Neither the frequency response nor a correction factor or some-
thing similar is required for the measurement