Spectrum Analyzer 1.
HMS-X 1 Basic Unit + 3 Options Key facts ❙ ❙ ❙ ❙ ❙ ❙ Frequency range: 100 kHz to 1.6 GHz/3 GHz*1 Spectral purity greater than -100 dBc/Hz (at 100 kHz) SWEEP from 20 ms to 1000 s Detectors: auto-, min-/max.-peak, sample, RMS, average, quasi-peak*2 Miscellaneous marker/Δmarker and peak functions Tracking generator*3 Frequency range: 5 MHz to 1.
HMS-X Your HMS-X Spectrum Analyzer You can create your HMS spectrum analyzer by combining a basic unit with any of three available options. In case of growing requirements, upgrade vouchers allow you to upgrade your instruments with all options at any point in time. 3 GHz HMS-EMC ❙ This option activates all the functions that are required for EMC precompliance measurements. The preamplifier option has been integrated into the new HMS-EMC option. HMS-3G ❙ The frequency range is increased from 1.
HMS-X upgrade Upgrade at any time You can easily upgrade all three available options at any later point in time with option upgrade vouchers available at your dealer. The voucher number and the serial number of your HMS-X instrument enable you to generate the respective licence key directly on our web page http://voucher.hameg.com. HV213 HV211 Activates EMC option HV212 HV211 HV211 HV211 Unlocks TG Upgrade to 3 GHz HMS-X HMS-X HMS-X options Option code*1 Voucher code*2 EMC option incl.
Precompliance EMC Precompliance Not only do unexpected results in test labs during EMC compliance measurements translate into extra costs, quite often they also cause a substantial delay for your project. HAMEG offers effective and cost-efficient tools for EMC precompliance measurements which allow you to successfully prevent possible surprises before the actual onset of a problem. Our HMExplorer software for your EMC measurements is included with every HMS-X spectrum analyzer with activated EMC option.
Accessories Recommended Accessories 3 GHz VSWR bridge HZ547 Near-field probe set 3 GHz HZ540 | HZ550 This unit is used to measure the voltage standing wave ratio (VSWR) and reflection coefficient of a device under test with an impedance of 50 Ω. Typical test devices include attenuators, terminations, frequency switches, amplifiers, cables and mixers.
Technical Data Spectrum analyzer HMS-X Firmware: ≥ 2.022 (RBW 10 kHz, VBW 1 kHz, ref. level ≤-30 dBm 10 MHz to 1.6 GHz/3 GHz*1) Frequency Frequency range: 100 kHz to 3 GHz Temperature stability: ±2 ppm (0 to 30 °C) Aging: ±1 ppm/year Preamp. deactivated (ref.
value-instruments.com www.hameg.com HAMEG Instruments GmbH Industriestr. 6 | 63533 Mainhausen | Germany | Tel +49 (0) 6182 8000 R&S® is a registered trademark of Rohde & Schwarz GmbH & Co.
