User manual

52
Remote Control
Once you open the Windows Device Manager, the follow-
ing entry will be displayed: “USB Test and Measurement
Devices --> USB Test and Measurement Device (IVI)”.
14.3 Ethernet
In addition to the USB interface, the interface card inclu-
des an Ethernetinterface.Congurethesettingsinthe
oscilloscope for all necessary parameters after you select
ETHERNET as interface and press the soft menu key PA-
RAMETER. You can specify all parameters and assign a
xedIPaddress.YoucanalsoassignadynamicIPaddress
with the activated DHCP function. Please contact your IT
managementtocon-gurethesettingsproperly.
If the device has an IP address, it can be accessed via web
browser at this IP since the HO730 includes an integrated
web server. Enter the IP address in the location bar on
your browser (http//xxx.xxx.xxx.xx). This opens a window
that includes the device name and type, serial number and
interfaceswithtechnicalinformationandconguredpa-
rameters. To the left, you can use the link Screen Data to
Fig. 14.8: Device manager
If DHCP is used and the system cannot assign an IP address to
the HMO (for instance, if no Ethernet cable is connected or the
network does not support DHCP), it may take up to three minutes
until a timeout allows the interface to be congured again.
Fig. 14.9: web server with device data
transfer a screenshot of the R&S®HMO1002 (Right-click to
copy to the clipboard for further use). The link SCPI Device
Control opens a site with a console to send remote SCPI
commands to the oscilloscope.