User manual

Remote Control

Select “Next“ to start the installation and follow the

installation instructions.

In this step, please select “NI-VISA xxx --> Leave this fea-

ture and its subfeatures installed locally“.

Now that you have successfully installed the NI-VISA driv-

ers, you can switch your R&S®HMO1002 to the USB-TMC

interface. Select the SETUP menu of your R&S®HMO1002,

and choose INTERFACE.

Fig. 14.2: NI-VISA installation instructions

Fig. 14.3: NI-VISA feature installation locally

Fig. 14.4: Setup menu

Use the soft key to select “USB” and the soft menu

PARAMETER.

Choose the USB type „USB TMC“.

Finally, use a USB interface cable (type A – B) to connect

thepowersupplywithyourWindowsPC.Ontherstuse,

the operating system issues the following message:

“Found New Hardware”. Once the installation has been

successfully completed, the following message will be

displayed: “Device Setup” - “USB Test and Measurement

Device (IVI), ready to use“.

Fig. 14.5: Interface menu

Fig. 14.7: Instrument driver installation

Fig. 14.6: Interface parameter menu