User manual

Subject to change without notice
15
DC-Offset: variable (on/off, except impulse function)
Offset range:
into 50Ω max. ± 2.5V
open circuit max. ± 5V
Trigger Output:
square wave synchronous
to signal outputs +5V / TTL
FM Input
(VCF, BNC-connector on rear panel of HM8001-2 and
Opt. HO801)
Frequency change: approx. 1:100
Input impedance: 6k Ω II 25pF
Protection voltage: ± 30V max.
Internal Sweep
Sweep speed: 20 ms to 15 s
Sweep range: approx. 1:100
General Information
Operating conditions: +10°C to +40°C
max. relative humidity: 80%
Supply (from HM8001-2): +5V/200mA
+16V/300mA;
-16V/250mA
(∑=9,8W).
Dimensions (without 22-pin fl at connector)
W x H x D: 135 x 68 x 228 mm;
Weight: approx. 800g
Operating Modes
Sine - Square - Triangle - DC - Pulse
free running, internal sweep, or external frequency modulati-
on, with or without DC Offset
Frequency Range
Total Range: 0.05 Hz to 10 MHz
(8 Decade Steps)
Variable Frequency
Adjustment: x0.09 to x1.1 (12:1)
Frequency Stability: <0.5%/h or 0.8%/day
at constant ambient temperature
(medium frequency control position)
Waveform Characteristics
Sine Wave Distortion
0.05 Hz to 1 MHz: max. 0.5%
1 MHz to 10 MHz: max. 5%
Square Wave Risetime: typ. 15 ns
Overshoot: <5%
(when output is terminated with 50Ω)
Triangle Non-Linearity: <1% (up to 100 kHz)
Display
Frequency: 5 digit, 7 segment LED;
8 x 5mm each
Accuracy:
up to 5 Hz: ±(1% + 3 digit)
5 Hz to 10 MHz: ±(5 x 10
-5
+ 1 digit)
LED-Indicator for: mHz, Hz, kHz and sec
Outputs
Signal Output: short-circuit proof
Impedance: 50 Ω
Output Voltage
into 50Ω 10 V
pp
open circuit 20 V
pp
Pulse Output Voltage
into 50 Ω: 5 Vpp
open circuit: 10 Vpp
Attenuation: max. 60 dB
2 steps: 20 dB ±0.2 dB each
variable: 0 to 20 dB
Amplitude Flatness: (sine/triangle)
0.05 Hz to 0.5 MHz: max. 0.2 dB
0.5 MHz to 10 MHz: max. 2.0 dB
Specifications
TECHNISCHE DATEN
Referenztemperatur: 23 °C ±2 °C
TECHNISCHE DATEN
Referenztemperatur: 23 °C ±2 °C
SPECIFICATIONS
Valid at 23 degrees C after a 30 minute warm-up
period
Included in delivery:
Function generator HM8030-6, Operating
manual
Optional Accessories:
BNC test cable HZ33/HZ34
50Ω Through termination HZ22