Instructions

Fernsteuerbefehle
R&S
®
Scope Rider RTH
420Bedienhandbuch 1326.1578.03 ─ 10
Parameter:
<Deviation> Absolute difference between mean value and upper/lower range
Bereich: 1E-15 bis 100E+24
Inkrement: 1
*RST: 0.707
Firmware/Software: FW 1.60 and higher
LOGGer:MEASurement<m>:VERTical:MEAN <Mean>, [<Deviation>]
Sets the mean value of the scaling range. In additiion, you can set the deviation. The
query returns the mean value.
The command disables the vertical auto scaling.
Use this command if you want to define the range based on the mean value and the
standard deviation, see LOGGer:MEASurement<m>:RESult:MEAN? and LOGGer:
MEASurement<m>:RESult:STDDev? auf Seite 426.
Suffix:
<m>
.
1..4
Logger channel
Parameter:
<Mean> Middle value between the upper and lower scaling value.
Einstellparameter:
<Deviation> Absolute difference between mean value and upper/lower sca-
ling value
Beispiel:
LOGGer:MEASurement1:VERTical:MEAN 10, 1
Sets the mean value to 10, and the deviation to 1. Thus, the
upper range is 10 + 1 = 11, and the lower range is 10 - 1 = 9.
Firmware/Software: FW 1.60 and higher
15.10.3 Cursor im Logger-Modus
15.10.3.1 Cursor-Einstellungen
LOGGer:CURSor[:STATe].............................................................................................. 420
LOGGer:CURSor:TYPE..................................................................................................421
LOGGer:CURSor:SCPLing............................................................................................. 421
LOGGer:CURSor:COUPling............................................................................................421
LOGGer:CURSor:SCReen..............................................................................................421
LOGGer:CURSor[:STATe] <Enabled>
Enables or disables the logger cursor measurement.
Daten-Logging