Instructions

Fernsteuerbefehle
R&S
®
Scope Rider RTH
418Bedienhandbuch 1326.1578.03 ─ 10
LOGGer:SLOT:LOAD
Loads the logger record of a slot, and activates the slot. The slot is defined using
LOGGer:SLOT:CURRent.
Verwendung: Ereignis
LOGGer:SLOT:CLEar
Deletes the log data of a slot. The slot is defined using LOGGer:SLOT:CURRent.
Only possible while logging is stopped.
Verwendung:
Ereignis
LOGGer:ACLR
Deletes the log data of all slots. Only possible while logging is stopped.
Verwendung:
Ereignis
15.10.2 Skalierung
LOGGer:AUToset...........................................................................................................418
LOGGer:MEASurement<m>:VERTical:AUTO................................................................... 418
LOGGer:MEASurement<m>:VERTical:UPPer...................................................................419
LOGGer:MEASurement<m>:VERTical:LOWer..................................................................419
LOGGer:MEASurement<m>:VERTical:DEViation..............................................................419
LOGGer:MEASurement<m>:VERTical:MEAN...................................................................420
LOGGer:AUToset
Sets all logger channels to automatic scaling.
Verwendung:
Ereignis
Firmware/Software: FW 1.60 and higher
LOGGer:MEASurement<m>:VERTical:AUTO [<State>]
Enables or disables the vertical auto scaling for the specified logger channel.
Using the command without parameter performs auto scaling once, without changing
the state.
Suffix:
<m>
.
1..4
Logger channel
Parameter:
<State> ON | OFF
*RST: ON
Daten-Logging