Instructions

Fernsteuerbefehle
R&S
®
Scope Rider RTH
403Bedienhandbuch 1326.1578.03 ─ 10
Parameter:
<ReferenceValue> Bereich: +/- (1.1 * measurement range)
*RST: 0
Std-einheit: V (VOLTage) | A (CURRent)
METer<m>:SENSe:NULL:VALU <ReferenceValue>
Sets the reference value for the currently active measurement type.
Relative measurements are not available for diode, continuity, and frequency measure-
ments.
Suffix:
<m>
.
1..4
R&S RTH1002: always 1, omit the suffix
R&S RTH1004: Selects the voltmeter.
Parameter:
<ReferenceValue> Bereich: +/- (1.1 * measurement range)
Std-einheit: Depends on the measurement type
15.8.4 Measurement Control
METer<m>:SENSe:FUNCtion......................................................................................... 403
METer<m>:CONFigure:VALue?...................................................................................... 404
METer<m>:TRIGger:MODE............................................................................................ 404
METer<m>:ABORt......................................................................................................... 404
METer<m>:SENSe:FUNCtion <MeasType>
Sets the measurement type for the selected meter. All measurement attributes of the
previous function (range, resolution, etc.) are remembered. If you return to the previous
function, the measurement attributes are restored.
Changing the measurement type disables scaling, limit testing, histogram, statistics,
and trend chart data collection: CALC:<function>:STAT is set OFF.
Suffix:
<m>
.
1..4
Selects the voltmeter.
Einstellparameter:
<MeasType> 'VOLTage:AC | VOLTage[:DC] | VOLTage:AD'
String parameter
*RST: VOLTage [:DC]
Beispiel:
MET2:SENS:FUNC "VOLT:AC"
MET2:CONF:VAL?
<--"VOLT:AC 1"
Sets the second voltmeter to AC voltage measurement.
Verwendung: Nur Einstellung
Voltmeter (R&S RTH1004)