Instructions

Fernsteuerbefehle
R&S
®
Scope Rider RTH
390Bedienhandbuch 1326.1578.03 ─ 10
METer:SENSe:RESistance:NULL:VALue <ReferenceValue>
Sets the reference value for resistance measurements. The measurement result is the
difference of the measured sample and the reference value.
The value takes effect if relative measurement is on, see METer:SENSe:
RESistance:NULL:STATe.
Parameter:
<ReferenceValue> Bereich: +/- (1.1 * measurement range)
*RST: 0
Std-einheit: Ohm
METer:SENSe:TEMPerature:NULL:VALue
<ReferenceValue>
Sets the reference value for temperature measurements. The measurement result is
the difference of the measured sample and the reference value.
The value takes effect if relative measurement is on, see METer:SENSe:
TEMPerature:NULL:STATe.
Parameter:
<ReferenceValue> Bereich: -200 bis 850
*RST: 0
Std-einheit: To define the unit, use METer:UNIT:TEMPerature.
METer<m>:SENSe:NULL:VALU <ReferenceValue>
Sets the reference value for the currently active measurement type.
Relative measurements are not available for diode, continuity, and frequency measure-
ments.
Suffix:
<m>
.
1..4
R&S RTH1002: always 1, omit the suffix
R&S RTH1004: Selects the voltmeter.
Parameter:
<ReferenceValue> Bereich: +/- (1.1 * measurement range)
Std-einheit: Depends on the measurement type
15.7.4 Measurement Control
METer:SENSe:FUNCtion................................................................................................391
METer:CONFigure:VALue?.............................................................................................391
METer<m>:TRIGger:MODE............................................................................................ 391
METer<m>:ABORt......................................................................................................... 392
Digitalmultimeter (R&S RTH1002)