Instructions

Fernsteuerbefehle
R&S
®
Scope Rider RTH
329Bedienhandbuch 1326.1578.03 ─ 10
TRIGger:SLEW:MAXWidth <MaxDuration>
Sets the upper time limit of the transition time for comparisons WITHin and OUTSide.
Parameter:
<MaxDuration> Bereich: 800E-12 bis 10000
Inkrement: 100E-9
*RST: 5E-9
Std-einheit: s
15.3.5.11 Data2Clock-Trigger (R&S RTH-K19)
Siehe auch: Kapitel 3.5.11, "Data2Clock-Trigger (R&S RTH-K19)", auf Seite 71.
TRIGger:DATatoclock:DSOurce[:VALue]..........................................................................329
TRIGger:DATatoclock:CSOurce[:VALue]..........................................................................329
TRIGger:DATatoclock:CSOurce:EDGE............................................................................ 329
TRIGger:DATatoclock:CONDition.................................................................................... 329
TRIGger:DATatoclock:HTIMe..........................................................................................330
TRIGger:DATatoclock:STIMe.......................................................................................... 330
TRIGger:DATatoclock:DSOurce[:VALue] <Source>
Selects the input channel of the data signal.
Parameter:
<Source> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
TRIGger:DATatoclock:CSOurce[:VALue] <Source>
Selects the input channel of the clock signal.
Parameter:
<Source> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
TRIGger:DATatoclock:CSOurce:EDGE <Slope>
Sets the edge of the clock signal: rising (POSitive), falling (NEGative), or both
edges (EITHer). The time reference point for the setup and hold time is the crossing
point of the clock edge and the trigger level.
Parameter:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
TRIGger:DATatoclock:CONDition <TrigCondition>
Selects how a violation of the setup and hold time is handled.
Grundeinstellungen