Instructions

Remote Control Commands
R&S
®
Scope Rider RTH
332User Manual 1326.1578.02 ─ 15
VIOLation
Triggers on a violation of the setup or hold time
OK
Triggers if setup and hold time keep the limits.
*RST: VIOLation
TRIGger:DATatoclock:HTIMe <HoldTime>
Sets the minimum time after the clock edge while the data signal must stay steady.
The hold time can be negative. In this case, the setup time has to be positive. The
setup time is defined by TRIGger:DATatoclock:STIMe.
Parameters:
<HoldTime> Range: -124E-9 to 124E-9
Increment: 1E-9
*RST: 1E-9
Default unit: s
TRIGger:DATatoclock:STIMe <SetupTime>
Sets the minimum time before the clock edge while the data signal must stay steady.
The setup time can be negative. In this case, the hold time has to be positive. The
setup time is defined by TRIGger:DATatoclock:HTIMe.
Parameters:
<SetupTime> Range: -124E-9 to 124E-9
Increment: 1E-9
*RST: 1E-9
Default unit: s
15.3.5.12 Serial Pattern Trigger (R&S RTH-K19)
TRIGger:SPATtern:DSOurce[:VALue]............................................................................... 332
TRIGger:SPATtern:CSOurce[:VALue]............................................................................... 333
TRIGger:SPATtern:CSOurce:EDGE................................................................................. 333
TRIGger:SPATtern:CSOurce:FIRStedge...........................................................................333
TRIGger:SPATtern:ORDer.............................................................................................. 333
TRIGger:SPATtern:PATTern............................................................................................ 333
TRIGger:SPATtern:DSOurce[:VALue] <Source>
Selects the input channel of the data signal.
Parameters:
<Source> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
Waveform Setup