Instructions

Remote Control Commands
R&S
®
Scope Rider RTH
310User Manual 1326.1578.02 ─ 15
Parameters:
<Position> Range: Depends on the time scale, see table below.
Increment: 0.1
*RST: 0
Default unit: s
Time scale Min./max. horizontal position
1 ns/div to 100 µs/div ±2 s
200 µs/div to 2 s/div Time scale * 20000
5 s/div – 500 s/div 100000 s
TIMebase:REFerence <ReferencePoint>
Defines the time reference point in the diagram.
Parameters:
<ReferencePoint> Position of the reference point in percent of the screen width.
Available values are:
10: on the left side of the screen
50: in the middle of the screen
90: on the right side
*RST: 50
Default unit: %
15.3.4 Acquisition Control
RUN............................................................................................................................. 310
STOP........................................................................................................................... 310
ACQuire:MODE............................................................................................................. 311
ACQuire:AVERage:COUNt..............................................................................................311
ACQuire:ARESet:IMMediate............................................................................................311
ACQuire:POINts:PRESelect............................................................................................ 311
ACQuire:WAVeformupd.................................................................................................. 312
ACQuire:POINts:ARATe?................................................................................................312
ACQuire:POINts[:VALue]?...............................................................................................312
ACQuire:RESolution?.....................................................................................................313
RUN
Starts the continuous acquisition.
Usage:
Event
STOP
Stops the running acquistion.
Usage:
Event
Waveform Setup