Instructions

Frequency Counter (R&S RTH-K33)
R&S
®
Scope Rider RTH
262User Manual 1326.1578.02 ─ 15
Remote command:
COUNter<m>:SENSe:TRIGger:MODE on page 416
COUNter<m>:INITiate on page 414
COUNter<m>:ABORt on page 411
Current Result
The currently measured counter frequency.
Remote command:
COUNter<m>:READ? on page 415
COUNter<m>:FETCh? on page 413
COUNter<m>:MEASure:FREQuency? on page 414
Minimum
The minimum of all measured counter frequencies since statistics were last restarted.
Remote command:
COUNter<m>:CALCulate:AVERage:MINimum? on page 412
COUNter<m>:CALCulate:AVERage:ALL? on page 411
Maximum
The maximum of all measured counter frequencies since statistics were last restarted.
Remote command:
COUNter<m>:CALCulate:AVERage:MAXimum? on page 412
COUNter<m>:CALCulate:AVERage:ALL? on page 411
Average
The average of all measured counter frequencies since statistics were last restarted.
Remote command:
COUNter<m>:CALCulate:AVERage:AVERage? on page 411
COUNter<m>:CALCulate:AVERage:ALL? on page 411
11.3 Performing a Counter Measurement
To perform a basic counter measurement without a reference
1. Before you can perform a counter measurement, adjust the waveforms by editing
the vertical, horizontal, trigger and acquisition settings.
For details see:
● Chapter 3.2, "Vertical Setup", on page 40
● Chapter 3.3, "Horizontal Setup", on page 45
● Chapter 3.6, "Trigger", on page 51
● Chapter 3.4, "Acquisition Control", on page 47
2. To adjust the instrument settings to the current input signal automatically, press
[AUTOSET].
Performing a Counter Measurement