Instructions

Frequency Counter (R&S RTH-K33)
R&S
®
Scope Rider RTH
261User Manual 1326.1578.02 ─ 15
Figure 11-3: Display for two counters simultaneously
1. To display both counters, tap the currently highlighted counter selection tab.
2. To return to a single counter display, tap one of the counter selection tabs.
In counter mode, the keys behave slightly different from scope mode:
●
The vertical [RANGE] and [POS] keys adjust the measurement range.
●
The [MEAS] key opens the "Counter" menu.
●
The following keys work as usual: [FILE],
, , [PRESET], [MODE], [BACK].
●
All other keys do not work.
Measurement Mode.................................................................................................... 261
Current Result............................................................................................................. 262
Minimum......................................................................................................................262
Maximum.....................................................................................................................262
Average.......................................................................................................................262
Measurement Mode
Tap the setting to switch between continuous measurement ("MANUAL") and a single
measurement ("HOLD"). This has the same effect as selecting the [TRIGGER RUN
STOP] key.
For a single measurement, the continuous measurement is stopped and the most
recent value is displayed.
During continuous measurements, the most recent value is preserved and displayed,
while the oldest values are overwritten.
Note: The statistical values are not reset when the measurement is stopped. They are
only reset after you manually select Restart.
Display and Control