Instructions

Protocol Analysis
R&S
®
Scope Rider RTH
237User Manual 1326.1578.02 ─ 15
"Slow Identifier and Data"
Sets the trigger to a combination of identifier and data condition from
the slow channel. The instrument triggers at the end of the last trans-
mission sequence which includes the last serial bits of the slow chan-
nel.
"Error condition"
Identifies various errors in the frame. You can select one or more
error types as the trigger condition.
Remote command:
TRIGger:SENT:TYPE on page 482
Status Pattern
Specifies the status pattern to be found, in binary or hex format. Enter the pattern in
MSB first bit order.
See also Chapter 3.6.12.1, "Pattern Definition", on page 71.
Remote command:
TRIGger:SENT:STATus on page 483
Status Relation
Defines how the specified status pattern is compared with the acquired signal. The
instrument triggers if the acquired address is equal or unequal the defined pattern.
Remote command:
TRIGger:SENT:SCONdition on page 483
Data Pattern
Specifies the data pattern to be found, in binary or hex format. Enter the pattern in
MSB first bit order.
See also Chapter 3.6.12.1, "Pattern Definition", on page 71.
Remote command:
TRIGger:SENT:DATA on page 482
Data Relation
Defines how the specified data pattern is compared with the acquired signal. The
instrument triggers if the acquired address is equal or unequal the defined pattern.
Remote command:
TRIGger:SENT:DCONdition on page 482
Identifier Pattern
Specifies the identifier pattern to be found, in binary or hex format. Enter the pattern in
MSB first bit order.
See also Chapter 3.6.12.1, "Pattern Definition", on page 71.
Remote command:
TRIGger:SENT:IDENtifier on page 483
SENT (Option R&S
RTH-K10)