Instructions

Data Logging
R&S
®
Scope Rider RTH
169User Manual 1326.1578.02 ─ 15
Position, Position Date
Sets the position of the zoomed area in relation to the left side of the display.
Remote command:
LOGGer:ZOOM:POSition on page 425
8.5.3 Logger Statistics
Figure 8-8: Logger statistics
1 = Measurement results; display depends on the logger mode and the selected measurement
2 = Mean value statistic
3 = Standard deviation statistic
Statistics are only shown if a single log is displayed.
Remote commands for logger statistics:
●
LOGGer:RECording:STARt? on page 425
●
LOGGer:RECording:TOTal? on page 426
●
LOGGer:MEASurement<m>:RESult:CURRentsampl? on page 426
●
LOGGer:MEASurement<m>:RESult:MAXimum:POSition? on page 426
●
LOGGer:MEASurement<m>:RESult:MAXimum:VALue? on page 426
●
LOGGer:MEASurement<m>:RESult:MINimum:POSition? on page 427
●
LOGGer:MEASurement<m>:RESult:MINimum:VALue? on page 427
●
LOGGer:MEASurement<m>:RESult:MEAN? on page 427
●
LOGGer:MEASurement<m>:RESult:STDDev? on page 427
●
LOGGer:MEASurement<m>:ENABled? on page 428
●
LOGGer:MEASurement<m>:TYPE? on page 428
●
LOGGer:MEASurement<m>:SOURce? on page 428
8.6 Export of Logger Records
Export means to save a logger record (slot) to a CSV or MAT file for further analysis.
Export is only possible if the instrument is in "Logger" mode. The instrument always
saves the data of the last saved slot, you cannot select the slot to be stored.
Export of Logger Records