Instructions

Data Logging
R&S
®
Scope Rider RTH
159User Manual 1326.1578.02 ─ 15
Figure 8-1: Logger display, view of all logged scope measurements
1 = Logger channel, each logger channel records one measurement
2 = Latest values of the logged measurements (depends on logging type and measurement type)
3 = Time basis
4 = In run mode (recording): →Slot <x> is the slot to which data is written. In stop mode: Slot <x> is the
active slot where data has been stored to or loaded from
5 = Recording time
6 = Start time
7 = Upper and lower scaling value of each measurement
8 = Time stamp of the left side of the display
Displaying logged measurements
1. To switch to one-log-view, tap on one of the logged measurements as shown in
Figure 8-1.
2. To view all logs, use one of the following methods, tap the highlighted number of
the open logger channel.
8.3 Using the Logger
You can log up to four different scope measurements, or meter measurements (one
with R&S RTH1002, four with R&S RTH1004), or two counter measurements simulta-
neously. Counter measurements require option R&S RTH-K33.
Using the Logger