Instructions

Multimeter Measurements
R&S
®
Scope Rider RTH
153User Manual 1326.1578.02 ─ 15
Figure 7-5: Four-voltmeter-view
1 = Channel measured by the voltmeter
2 = Bargraph displaying the measured value
3 = Measurement ranges of active channels
In meter mode, the keys behave different from scope mode:
●
The vertical [RANGE] and [POS] keys both adjust the measurement range of the
selected channel.
●
The [MEAS] key opens the "Meter" menu.
●
The following keys work as usual: [FILE],
, , [PRESET], [MODE], [BACK].
●
All other keys do not work.
Displaying voltmeters
► To switch to one-voltmeter-view, use one of the following methods:
● Tap the meter number as shown in Figure 7-5.
● Turn the wheel to select a voltmeter, and press the wheel button to open it.
► To view all 4 voltmeters, use one of the following methods:
● Tap the highlighted number of the opened voltmeter as shown in Figure 7-4.
● Press [BACK].
7.2.3 Running Voltmeter Measurements
1. Set up the channels for voltmeter measurements in the "Vertical" menu.
See Chapter 7.2.5, "Vertical Settings", on page 156.
2. If the 4-voltmeter-view is shown, switch to the one-voltmeter-view.
Voltmeter (R&S
RTH1004)