Instructions

Mask Testing
R&S
®
Scope Rider RTH
108User Manual 1326.1578.02 ─ 15
Width X
Changes the width of the mask in horizontal direction.
The specified number of divisions in divisions is added to the positive x-values and
subtracted from the negative x-values of the mask limits in relation to the mask center.
Thus, the left half of the mask is pulled to the left, the right half is pulled to the right.
To apply the changed value to an existing mask, tap "Create Mask".
Remote command:
MASK:CHANnel<m>:PROPerties:XWIDth on page 352
Width Y
Changes the width of the mask in vertical direction.
The specified number of divisions is added to the y-values of the upper mask limit and
subtracted from the y-values of the lower mask limit. Thus, the upper half of the mask
is pulled upwards, the lower half is pulled down, and the overall height of the mask is
twice the "Width Y".
To apply the changed value to an existing mask, tap "Create Mask".
Remote command:
MASK:CHANnel<m>:PROPerties:YWIDth on page 353
Create Mask
Creates a new mask, or applies modified mask settings to the mask.
If "Coupling" is enabled, all active masks are recreated with the settings of the selected
mask.
Remote command:
MASK:CHANnel<m>:CREatemask on page 353
Action on Violation
Selects the action to be executed if the mask limits are violated.
This action is applied to all masks.
Remote command:
MASK:ONViolation[:SELection] on page 353
Save all Masks
Opens an explorer to save all active masks.
Load all Masks
Opens an explorer to load masks.
If an acquisition is running, the acquisition is topped until the masks are reloaded.
[RUN] / [STOP]
Starts and stops triggering on mask violations.
Remote command:
RUN on page 310
STOP on page 310
Mask Settings