Owner`s manual

5
4. While holding SET, press the desired combination piston. Then release both
pistons.
 LOCKING A COMBINATION MEMORY:
1. Press and hold M1, M2, M3 or M4 for approximately five seconds. “USING
INTERNAL MEMORY” appears in the Console Display first, followed by
“MEMORY (#) UNLOCKED” .
2. While continuing to hold the memory piston, rotate the Alpha Dial in either
direction until the Console Display reads “MEMORY (#) LOCKED.”
3. Release the memory piston. The memory is now locked.
 SPECIAL FEATURE - PEDAL STOPS CAN BE SET TO BE CONTROLLED BY
GREAT PISTONS:
PEDAL TO GREAT PISTON COUPLER
This feature allows the Great divisional pistons to also operate the like-numbered Pedal
divisional pistons. When this mode is selected, pressing a Great divisional piston will also
light the corresponding Pedal divisional piston. Also, stops stored on the Great and Pedal
divisional piston may be set by holding SET and pressing a Great divisional piston. To
Change the Pedal to Great Piston Coupler Mode:
• From the Transposer menu display, press and hold SET, then turn the Select knob
counterclockwise to locate the PED TO GT PISTON COUPLER menu item. The
SET piston may be released once the Transposer menu item is no longer displayed.
PED TO GT PISTON
COUPLER
• Use the Adjust dial to change the setting to ON or OFF. The setting will be
remembered when the organ is turned off. (The default setting is OFF.)
• Press General Cancel to return to the Transposer display.