Owner`s manual

2. When the memory contents have been correctly received, the memory piston

corresponding to the memory on the sequencer recording flashes. At this point, the

contents of the memory are stored in a temporary holding area in the console.

3. Stop the sequencer playback.

4. Press and hold SET, then press the memory piston for the desired destination.

Note: This need not be the same memory as the memory whose piston is flashing.

When copying more than one memory to the sequencer, it is necessary to wait a few

measures between saving individual memories, or place them on different tracks. This

procedure will reduce confusion regarding the location of the memories on the sequencer.

When playing back the memories, play only one at a time. Each time the organ starts to

receive a new memory, it discards any previous information in the temporary holding area. It

is necessary to transfer each memory to its destination memory in the organ before playing

back the next.

MIDI CONNECTIONS

Always connect a sequencer to the Sequencer IN/OUT ports on the organ.

The

sequencer must not be in “Soft Thru” mode.

Any other MIDI instruments or keyboards

should use the ports labeled “MIDI.”