Owner`s manual

35
MIDI DEVICE ID
MIDI Device ID allows the organist to select the MIDI Device identification number used
in System Exclusive Stop Control messages. Normally, the organ both sends and recognizes
an ID number of 17. Stop Control messages with other ID numbers will be ignored.
This ID number can be changed to allow independent control over multiple organ
consoles connected via MIDI or to facilitate storing multiple sets of registration information
on a sequencer recording. The number can be set to 1, or 17 through 32. Setting the ID to 1
produces Stop Control messages which are compatible with older Rodgers PDI and
C-Series organs. The ID always returns to 17 when the organ is turned off.

SETTING THE MIDI DEVICE ID:
1. Press and hold the SET piston, then turn the Select Knob clockwise (right) to
“MIDI DEVICE ID”.
2. Rotate the Alpha Dial to set the desired ID number.
3. Press General Cancel to exit.
SAVING A COMBINATION MEMORY
The contents of any combination memory may be saved into a MIDI sequencer and later
reloaded into the organ.
1. Connect the Sequencer MIDI IN to the organ Sequencer MIDI OUT. Connect the
Sequencer MIDI OUT to the organ Sequencer MIDI IN.
2. Start the sequencer in Record mode.
3. Wait until after any count-in measures, then hold the SET piston and momentarily
press the memory piston (M1, M2, M3 or M4) for the memory to be copied to the
sequencer.
4. Release SET and wait until the Console Display reads:
MEMORY COPIED TO
SEQUENCER PORT
5. Stop the MIDI Sequencer, or wait a few seconds and repeat steps 3 and 4 above to
send another memory to the sequencer. Always leave a few measures of space
between memories.
To reload a memory from the sequencer, first connect the sequencer following the steps
above. Then continue:
1. Play back the recorded memory as a song would be played back.