Owner`s manual

32
3. Press the desired combination piston.
4. Release both pistons.
The factory default settings for the MIDI coupler pistons are:
MIDI GT A = CH 1*
Program Change (PGM) = OFF
Variation (VAR) = 0
Octave Transpose = NORM
Velocity (VEL) = 64
* This channel will be different for each MIDI coupler piston. Note: Please refer to the
MIDI channel list at the beginning of the MIDI section.
Remember, MIDI default settings can be changed by performing a MIDI Save procedure.
ENABLING/DISABLING MIDI MASTER CHANNELS
The Rodgers 795 reserves several MIDI channels for recording and playback of the organ
using a MIDI sequencer. One channel is reserved for each division as follows:
Great Master Channel Notes and Expression 12
Swell Master Channel Notes and Expression 13
Pedal Master Channel Notes and Expression 14
The organ sends and receives MIDI information on these channels unless they are
disabled. It may be necessary to disable one or more Master Channels when using the organ
console as a MIDI keyboard controller in multi-track or multi-layer sequencing, to avoid
duplicating note data on multiple tracks.

ENABLING OR DISABLING A MIDI MASTER CHANNEL:
1. Press and hold the SET piston, and turn the Select Knob clockwise (right) to
“MIDI MASTER CHANNEL”.
2. Place the cursor on the division name field (“GT”, “SW”, or “PED”).
3. Rotate the Alpha Dial until the desired selection is displayed.
4. Turn the Select Knob clockwise (right) to move the cursor to the channel status
field (“OFF”, “RCV ONLY”, “SEND ONLY”, “SEND & RCV”).
5. Rotate the Alpha Dial to set the Master Channel status for this selection. Note:
Turning a manual’s Master Channel off prevents the organ from sending or
receiving notes or expression on that channel.
6. Press General Cancel to exit.