Owner`s manual

31
 ASSIGNING MIDI CHANNELS:
1. Hold the SET piston, then press MIDI GT A. The coupler piston flashes.
2. Turn the Select Knob clockwise (right) until the cursor moves to the channel
number.
3. Rotate the Alpha Dial to set the channel number.
4. Press either the flashing MIDI coupler piston or General Cancel to exit.
The channel number for MIDI GT A coupler piston can be saved in the settings on a
combination piston or saved permanently by performing the MIDI Save procedure. Note: A
MIDI Save may be performed to save this setting as the default. Please refer to the “MIDI
Save” section.
MIDI SAVE
Changes made to MIDI settings are temporary and will be lost when the organ is turned
off unless those settings are saved. This is done by performing the following procedure.
 SAVING MIDI CONTROL SETTINGS:
1. While in any MIDI menu, make the desired changes.
2. To save, press and hold the SET piston, then press and hold General Cancel for
approximately five seconds.
2. Continue holding both pistons until the Console Display reads:
ALL MIDI
SETTINGS SAVED
3. Release both pistons.
SUSTAIN SWITCH
A foot switch is located on the top left edge of the Great/Pedal expression shoe. This
switch will sustain MIDI sounds playing from MIDI GT A coupler piston. Press the switch to
sustain, release to stop.
ADDITIONAL MIDI SETTINGS ON COMBINATION PISTONS
After additional MIDI settings have been selected on a MIDI coupler piston, these
settings can be saved on any General or corresponding Divisional combination piston.
 SAVING MIDI SETTINGS ON A COMBINATION PISTON:
1. Select the MIDI coupler piston (and organ stops, if desired).
2. Press and hold the SET piston.