Owner`s manual

22
3. Release SET.
4. Rotate the Alpha Dial to select the setting to be adjusted (“VOLUME”,
“BALANCE”, “BASS”, or “TREBLE”).
5. Turn the Select Knob clockwise (right) to place the cursor on the bottom line.
6. Rotate the Alpha Dial to set the desired value.
AUXILIARY INPUTS
The Rodgers 795 is equipped with stereo Auxiliary Input Jacks (one for the left channel
and one for the right channel) located on the Connector Panel under the keydesk to the right.
When using these input jacks, audio signals from other sound generating devices like
synthesizers, MIDI sound modules, and tape players are mixed into the organ’s main audio
system. A series of Console Display menu controls is used to adjust the characteristics of the
Auxiliary Input sound.

ADJUSTING THE AUXILIARY INPUTS:
1. Press and hold the SET piston.
2. Turn the Select Knob counterclockwise (left) to “AUX”, and place the cursor on
the top line.
3. Release SET.
4. Rotate the Alpha Dial to select the desired control.
5. Turn the Select Knob clockwise (right) to place the cursor on the bottom line.
6. Rotate the Alpha Dial to obtain the desired effect. Note: An Audio Save may be
performed to save this setting as the default. Please refer to the “Audio Save”
section.
STEREO LINE OUTPUTS
The Rodgers 795 is equipped with stereo Line Outputs also located on the Connector
Panel. When using these outputs the divisions of the organ (Great, Swell, and Pedal) are
heard in stereo. There is no specific channel assignment (left or right) given to these divisions.
The volume may be adjusted by performing the following procedure:

ADJUSTING THE STEREO LINE OUTPUTS:
1. Press and hold the SET piston.
2. Turn the Select Knob counter clockwise (left) to “LINE OUT GAIN”.
3. Release SET.
4. Rotate the Alpha Dial to adjust the volume .
Note: An Audio Save may be performed to save this setting as the default. Please
refer to the “Audio Save” section.