Owner`s manual

 ADJUSTING THE TREMULANT SETTINGS:

1. Starting from the TRANSPOSER display, press and hold the SET piston.

2. Turn the Select Knob counter clockwise (left) until the Console Display reads:

GT MAIN TREM

RATE 0 DEPTH 0

3. Turn the Select Knob until the cursor is on the tremulant name. Note: Please refer

to the “795 User Menu Items” section for a list of tremulant names.

4. Rotate the Alpha Dial until the Console Display reads the tremulant to be adjusted.

5. Turn the Select Knob until the cursor is on the rate.

Rotate the Alpha Dial until the Console Display reads the desired tremulant rate.

Note: The range is from -9 to +9. The rate setting may be previewed by selecting a

corresponding stop and playing a note while the adjustment is made.

7. Turn the Select Knob clockwise to move the cursor to Depth, then adjust as with

the Rate.

TUTTI

There are times when a full organ registration is needed immediately. The Tutti on the

Rodgers 795 can be set with any combination of stops. Press the TUTTI piston to access the

Tutti combination. These pistons are reversible, so simply press again to cancel. When Tutti

is in use, the top four segments of the Crescendo/Tutti indicator light red. The

Crescendo/Tutti indicator is located on the stop rail to the far right. Stops and couplers set on

Tutti add to the registration selected by the knobs/tabs, but do not light the additional stop

controls.

 VIEWING THE TUTTI SETTING:

1. Press and hold the TUTTI piston or toe piston.

2. While holding the TUTTI piston, press the SET piston. The stops of the Tutti

setting light.

Note: Tutti cannot be set unless it is unlocked.

 UNLOCKING THE TUTTI:

1. Press and hold the TUTTI piston for approximately five seconds until “TUTTI

LOCKED” appears in the Console Display.

2. While continuing to hold TUTTI, rotate the Alpha Dial either direction until the

Console Display reads “TUTTI UNLOCKED.”

3. Release the TUTTI piston. The Tutti is unlocked.