Owner`s manual

8. When building a completely new sequence, it is advisable to first write the new

sequence down without numbers, then assign stage numbers from 1 to 63 to each

stop or group of stops in the sequence. Sometimes there are more stages than stops

in the sequence, so it is necessary to skip some stages to make the sequence end at

or near stage 63. If this is not done, the sequence ends before the Crescendo Pedal

is fully depressed.

9. To exit the “CRESC SET MODE” menu at any time, press General Cancel. Any

changes in the sequence made up to this point are saved.

Note: If the original factory setting is desired, please refer to the “Restoring the Factory

Crescendo Setting” section below.

 LOCKING THE CRESCENDO:

1. Press and hold the CRESC piston for approximately five seconds until

“CRESCENDO UNLOCKED” appears in the Console Display.

2. While continuing to hold CRESC, rotate the Alpha Dial either direction until the

Console Display reads “CRESCENDO LOCKED.”

3. Release CRESC. The Crescendo is locked.

 RESTORING THE FACTORY CRESCENDO SETTING:

1. Press and hold the CRESC piston for approximately five seconds. The Console

Display reads “CRESCENDO LOCKED” or “CRESCENDO UNLOCKED”,

change to “CRESCENDO UNLOCKED.”

2. While continuing to hold CRESC, press and hold SET for an additional five

seconds. The Console Display reads “CRESCENDO FACTORY DEFAULT”.

3. Release both pistons.

TREMULANTS

Tremulants create a change in pitch (sharp and flat), amplitude (volume) and timbre (tone

quality). The use of the tremulant adds warmth to solo or small ensemble combinations. It is

not common to use tremulants in larger classical ensembles. In some romantic ensembles,

tremulants are used judiciously. In some gospel and evangelical musical traditions, tremulants

with a faster and deeper excursion are frequently used.

There are two types of tremulant controls on the Rodgers 795. The Divisional tremulants

(Great and Swell) affect only the stops in the respective division. There is one General

tremulant, the FLUTE II (FLT TREM II piston) tremulant, which affects all manual flute stops

simultaneously.

All tremulants may be individually adjusted for rate and depth by performing the

following procedure: