Owner`s manual

There is a lighted Crescendo/Tutti indicator located on the stop rail to the far right, with

eight lighted green segments to indicate the progressive stages of the Crescendo as the pedal is

depressed.

The selection of stops to be added by the Crescendo shoe may be set by the organist.

The Crescendo must first be unlocked to set a crescendo sequence. Once the sequence is

set, it may be locked again to prevent accidental change.

 UNLOCKING THE CRESCENDO:

1. Press and hold the CRESC piston for approximately five seconds until

“CRESCENDO LOCKED” appears in the Console Display.

2. While continuing to hold CRESC, rotate the Alpha Dial either direction until the

Console Display reads “CRESCENDO UNLOCKED.”

3. Release the CRESC piston. The Crescendo is unlocked.

 SETTING THE CRESCENDO SEQUENCE:

1. Press and hold the SET piston.

2. Press the CRESC piston. The piston flashes, and the Console Display reads:

CRESC SET MODE

STD STAGE 1

The stops and couplers currently set on stage one of the 63 stages in the Crescendo

sequence turn on.

3. The current sequence may be viewed by advancing through the stages one at a time

using the Alpha Dial. At each stage, the stage number (1 to 63) is indicated in the

Console Display, and the stops and couplers set at this stage turn on.

4. To add a stop to the sequence, go to the stage where the stop is to be added, turn

the stop on, and press SET. More than one stop may be added on the same stage.

5. To delete a stop, go to the first stage in which the stop turns on, turn the stop off,

and press SET.

6. Each stop can be turned on at any stage and turned off at any later stage. As an

example, assume the GREAT FLUTE CELESTE II is to turn on at stage 1 and off

at stage 25. Go to stage 1, turn on the GREAT FLUTE CELESTE II, and press

SET. Then go to stage 25, turn off the GREAT FLUTE CELESTE II, and press

SET.

7. To clear the entire Crescendo sequence (stages 1 through 63), hold SET and press

General Cancel (0). This also resets the current stage number to 1 so that a new

sequence can be entered.