Owner`s manual

48
Error Messages
An error message appears in the display when an error in operation occurs, or if an operation cannot be
processed correctly. When this occurs, continue by following the instructions indicated in the error message.
Display Situation Action
More MIDI messages were received in a short time
than could be processed correctly.
Reduce the amount of MIDI messages that are
transmitted.
There is a problem with the MIDI cable connected
to the XV-2020’s MIDI IN connector or with an ex-
ternal device. However, this message is also dis-
played when the power for the external device is
turned off.
Check to make sure the MIDI cable is firmly and
properly connected. Otherwise confirm that there is
no short in the MIDI cable (try switching the MIDI
cable to check this).
A system exclusive message that was received had
an incorrect check sum value.
Correct the check sum value.
The MX-200’s special expansion board is not in-
stalled.
Remove the MX-200’s top cover, then check to make
sure that the special expansion board is firmly and
properly installed in the MX-200.
A system exclusive message was not properly re-
ceived. Repeated appearance of this same error
message means that there is a problem with the
MIDI message.
Check the content of the received system exclusive
message.
USER data has been damaged. Restore the factory settings with the Factory Reset
procedure.
It is possible that the power has been turned off for
the computer connected to the XV-2020’s USB con-
nector.
Check the power of the connected computer.
It is possible that a USB cable has been pulled out or
has a short.
Check the USB cable.