Owner`s manual

Adjusting your Organ

Other Settings

■ Making USB and MIDI Related Settings

Procedure

1. Hold down [VOLUME] and press [VALUE] to

enter Edit mode.

2. Turn [TONE CATEGORY] to select “CELESTE

(SETUP MODE).”

3. Turn [PART] to select the parameter.

4. Turn [VALUE] to select the desired setting.

5. Press [VALUE] to set (write) the value.

6. Press [VOLUME] to exit Edit mode.

* With these parameters, changes in the settings are not reflected until the power is turned off and then on again.

Furthermore, only the MX-200 can be used to make the settings.

■ Checking the Program Version

Procedure

1. Hold down [VOLUME] and press [VALUE] to

enter Edit mode.

2. Turn [TONE CATEGORY] to select “CELESTE

(SETUP MODE).”

3. Turn [PART] to “5 (VER.DISPLAY).”

The program version (number) is displayed.

4. Press [VOLUME] to exit Edit mode.

PART

Knob

Position

Parameter Value Description

6 PERFORMANCE

CONTROL CHAN-

NEL

1–16, OFF When MIDI messages from an external device are used to switch the

MX-200’s Organ Type setting, set the external device’s transmission

channel and this channel setting to the same channel.

* After Factory Reset, this is set to “OFF.” Do not change this setting

unless you have a particular need to do so.

7 USB DESCRIPTOR VEN, GEN This parameter will be used with future expansions. Although it nor-

mally does not affect operations, keep it set to “VEN” anyway.

VEN (VENDOR): Select this setting.

GEN (GENERIC): Do not select this setting.

8 MIDI-USB THRU OFF, ON This parameter will be used with future expansions. Ordinarily, you

should keep this set at “OFF.”

9 RECEIVE GM2 ON OFF, ON This setting determines whether GS RESET, GM SYSTEM ON, and

GM 2 SYSTEM ON MIDI messages are received (ON), or not (OFF)

(p. 26).

* This is normally set to “ON.” Set this to “OFF” only when record-

ing the MX-200’s tones while using the MX-200 in combination

with a PR-300S.